Strategies For Preserving Your Lathe To Extend Its Existence

A great lathe can serve as the building blocks for effective woodturning. As the lathe that you select doesn’t always need to be costly, it needs to be produced from quality materials, be-designed and appropriate for your skills and intended skill development in order that it doesn’t constrain your ambitions and skills in Woodturning.

However, purchasing the very best lathe for the projects is simply the start of the process. Indeed, after prolonged use, your lathe may benefit from a little bit of ‘TLC’, so regular maintenance is important if it’s to carry on delivering the most performance.

We advise a normal lathe maintenance check in your woodturning regime, that you may adopt the next steps. Blowing and brushing off woodchips after turning, for instance, is really a habit that woodturners should get as, when forest shavings cover areas of the lathe like the motor cooling vents, its motor can overheat and put on.

Wiping lower your bed, top, underneath and inside your lathe is similarly crucial. Shield Technologies Protectool wax polish applied having a Chestnut Priooducts Nyweb pad is fantastic for keeping the bed smooth and making your banjo and tailstock simple to adjust. Removing debris out of your lathe also helps to ensure that there is not anything between your bed and banjo or tailstock to avoid them from locking lower tightly.

We suggest that you take your finger within the tool rest to check on that it’s smooth, and when it is not, level the remainder having a file or coarse abrasive. It is really an important technique of keeping the tool rest level so your passes are smooth and unobstructed, most famously since steel of the tool will usually harder compared to your tool rest, and sharp-edged, raising the potential of divots because of the tool being knocked to the rest by the act of turning.

Regularly inspecting your lathe’s drive belts for put on and cracks will assist you to prevent inconvenient breakages in the center of your woodturning sessions, and keep the headstock ‘swallow’ free from excess chips and debris will make sure that your dead center spins true. You ought to be especially aware of the possibility of the headstock threads being hindered by chips, dings, dents and corrosion.

As the aforementioned lathe maintenance tips will definitely enable you to gain the utmost productivity and cost out of your lathe, additionally, it remains vital to purchase the best lathe. So, why don’t you get your next lathe from your extensive and famous range at The ToolPost, whether through our website or perhaps in our Didcot showroom and shop?

Leave a Reply

Your email address will not be published. Required fields are marked *